Thermostat temp 860i
What is the temp of the thermostat in our machines? I installed a cab heater that works off of the colant system and it has a separate thermostat for heat to the heater. It seems like the 2 aren't...
View Article2013/14 825i gators at Auction
Aloha, I am a newbie, and am about to go to Auction, regarding a fleet of gators being sold. Being as I am still learning up; on these I wanted to ask the forum about opinions on fair market value of...
View ArticleRSX Clutch Puller
Going to ask again. Does anyone have a JDG 11200 clutch puller they can post the dimensions of ??? Can't buy one from Canadian dealers and want to install an EPI kit. Is thread M18x1.5 ? Length ? Pls...
View ArticleClik here to view.
my 6x4 fires right up & stalls
just started my 6x4 gator and it stalls right out and i smelled gas,,i found a clear hose that comes off the back of the carb that fuel is pouring out of when i start it,,it will run for a few seconds...
View ArticleDash
Kind of new to this site. Gator 825i 2011 dash panel has a short in wiring comes on goes out any thoughts. Or wording digram? Thanks
View ArticleClik here to view.
Why Is My ATV So Difficult To Start
Quote: ATV AnswerMan looks into a problem Honda Rancher 400 When my Honda Rancher 400 sits for a day or more, gas drains back to the tank making it a five-minute crank to start. What can I do to fix...
View ArticleClik here to view.
Clutch Puller- JDG 11200- Spec's
Thought I would put these up under the Projects and How-To- Section, if you should use these specifications please understand I'm not responsible for any measurement errors. A 6.5000 in B 2.8630 in C...
View ArticleClik here to view.
Clutch Puller- JDG 11200- Spec's
Thought I would put these up under the Projects and How-To- Section, if you should use these specifications please understand I'm not responsible for any measurement errors. A 6.5000 in B 2.8630 in C...
View ArticleClik here to view.
Clutch Puller JDG 1641
Specifications for JDG 1641- I'm assume no responsibility for measurement errors. A 6.5000 in B 3.6610 in C 3.5590 in D .9760 in E .5760 in DIA .7070 TPI 18 Attached Thumbnails Â
View ArticleMaxis tires
I just bought some bighorn 26x9x14 tires and they are the exact same width as my current 26x8x14 it that normal for that brand
View ArticlePowertach plow
I have a powertach plow and the hydraulic pump motor is not running up to speed. I see that it is the same motor used on boat trim/tilt units. Can I use one of these motors?
View Article2012 RSX850i sport.
Never had a gator before, thought I was buying one for a good deal from a cousin. I may have been wrong. Already will not start back after it died hauling off trash.
View ArticleRSX850i engine locked up possibly.
Just purchased a 2012 RSX850I and it ran great. Brought it home and with taking the trash off across the road twice and riding it home it shut off and will not turn over. Like it is locked up. Got...
View ArticleQuestions for previous Ranger owners
I am currently an owner of a 2015 Ranger XP900 and I would like to hear some feed back on former ranger owners that made the switch to the green side. I have driven an 825i a little bit that a friend...
View Article825i clutch box bolts
I'm trying to open the cover for the clutch and am having issues trying to get to the bottom bolt. It seems wedged right behind the lower frame bar. Is there a secret to getting to it?
View ArticleHelp
starter selinoide will not disengage.pulled the red wire that engages the selinoide and it stops. Pulled the key switch and it still does it.
View Articlechanging tire diameters
I have a 2014 825i was changing clock and found the tire diameter thing. I thought it meant rim size and changed to 14. It changed the top speed to 23mph. Is this normal or did I do something else to...
View ArticleClik here to view.
Turn signals
Has anyone installed turn signals on the RSX? I'm looking for ideas. I found some kits on eBay but not sure how I would mount the lights. Not really looking to cut into my plastic, but not dead-set...
View ArticleNew to me 2000 gator
I just picked up a 2000 gator 4x2 from the original owner, and she is an acquaintance that I don't know well. While I have no reason to doubt her recollection as to when she bought it, I would like to...
View ArticleYear/Model
Hello, I'm new to the forum. I live in northern Alabama on a small 11 acre farm. I have a 30 horse yanmar tractor and my 6 X 4 gator with Curtis cab. The person I bought it from didn't know much about...
View Article