changing tire diameters
I have a 2014 825i was changing clock and found the tire diameter thing. I thought it meant rim size and changed to 14. It changed the top speed to 23mph. Is this normal or did I do something else to...
View ArticleYear/Model
Hello, I'm new to the forum. I live in northern Alabama on a small 11 acre farm. I have a 30 horse yanmar tractor and my 6 X 4 gator with Curtis cab. The person I bought it from didn't know much about...
View Articlelocking fuel caps 825i and 509i gators
does anyone know where a person can get a locking fuel cap for these models? have had a lot o inquiries about these?
View Article620i back cylinder very lean, no fuel
2008 620I Gator is running with low power. Idles and starts fine, but low power when under load and/or top end. I've put a new fuel filter. Removed and cleaned the throttle body and injectors with carb...
View ArticleBeen Lurkin
Hi guys! New member here. First i want to thank everyone for the info I have found on this forum. I purchased my RSX 860i back in early November and so far I am very satisfied with it. I have installed...
View ArticleClik here to view.
Winch bumper
Guys, I have recently talked with wild boar atv and they will be building me a front winch bumper, Which means they will start selling them. They will have my machine for a few days to get measurements...
View ArticleFor Sale- 825I Engine- Complete
I have a 2012 825I engine for sale. It is complete with injectors, ECU, wiring harness, alternator ( high amp), starter etc. In a JD crate, ready to ship from Riverton Wyoming 82501 Engine was running...
View ArticleNot cranking
I have a 2000 6x4 gas gator. It is not cranking over (silence). Fuel pump works. replaced ignition switch, getting voltage. replaced start relay. replaced starter solenoid. voltage checks to nuetral...
View ArticleFront 4WD not working
Hi Folks, I have a 2015 825i and have discovered that the front differential is not engaging when I press the switch and apply throttle. I have checked the wire harness and applied dielectric grease. I...
View Articleserial #
Just bought an older 6x4, ser.# woo6xx4----871 missing 3 to 4 # or letters in middle. is there somewhere else on the machine that will have the #. Also do the engines run on reg 87 oct. or the higher...
View Articlersx engine for sale
RSX engine for parts. make offer, bad rod, i think crank is salvageable 608-963-0410
View ArticleClik here to view.
Cargo Bed Lift Cylinder
I have a new lift cylinder of a 825i gator, PN AM145337. They go for $70.00, I'm asking $30.00 shipped. PM me and I will get back to you. Attached Thumbnails
View ArticleWinch Rope?
Wondering if anyone has tried putting 1/4" synthetic on thier warn provantage winch and if so how many feet did you get rolled up on it?
View ArticleXUV825i with Camso tracks at high altitude
Wondering if anyone has experience with the tracks at high elevation. Our mountain place in Colorado is at 11,400 feet and I'm wondering about how the Gator will perform there with the tracks. I would...
View Articlesteamdust
I have a mid 1990-early 2000 Gator 6x4 Diesel. It was running when i put it in the shed but now wont start. looking for electrical diagrams for the glow plug relay as the glow plug light doesn't come...
View Articlelawn attachments
anyone on here use any tow-behind products for aerating, seeding, fertilizing, thatching, etc? i was thinking about buying some stuff from agri fab to do these tasks but im not sure if theyre really...
View Articlemaking a rsx 850i go as fast as 860i any ideas?
just wondering if anyone has heard how they got the rsx 860i to go alittle faster wanna make my 850i go alittle faster...i had the header and chip but took it off it was way to loud my wife would not...
View ArticleGator XUV 855D Loses Power Operating Tempature
I have a Gator XUV 855D with an awkward problem all of the fuel and air components have been checked or replaced. Starts with no problem hot or cold weather, runs fine until it reaches operating...
View Articleatvsilencer.com
Has anyone tried this silencer on their 850 or 860? How much did it reduce noise? https://www.atvsilencer.com/johndeere.html
View ArticleNewly painted 620i
I recently painted my 2008 620i. It was originally camo but within the last year the camo started to flake off. My brother being a paint man, guided me in the direction of what I need to do to the...
View Article