New to forum
Hi, I am new to forum and look forward to seeing what you folks are doing. I just bought a Gator XUV 825i and am looking forward to being able to go exploring with it. Thanks, JD
View Articlex825i and the physically challenged
I bought a x825i yesterday and after I got home I had one of those "duh, you jackass" moments. With the height of the unit its going to be near impossible for one of my wife to get in and out of the...
View ArticleNew to the gator community few wuestions
I bought a 2011 gator hpx gas. Finding stuff for it is a hard thing. Is this year rare? Do they make lift kits for it? What bolt pattern is it? And what's it's worth. It has 2800hrs in great shape. Has...
View ArticleIs there a 12v outlet available on the 825i
Hi, I was looking at hooking a gps up to a Gator XUV 825i and was wondering if there was a 12volt outlet available. Thanks JD
View ArticleIntro
Hi everyone. I'm Jason from Texas and my wife and I are starting a small farm with 21 acres. We'll be raising sheep, chickens, ducks and miniature cattle. On Friday I bought a used 1989 John Deere AMT...
View ArticleAMT 622 Shifting
Hi Everyone: I bought an AMT 622 on Friday. Shifting is a challenge and I have to try several times to get each gear to engage. I find that pulling up on the handle helps get it in neutral. This is my...
View ArticleNeed Help ---- RSX 850i Clutch Puller
I know this has come up before but can some one advise the thread pitch and dimensions for the JDG 11200 puller???? I'm in Canada and the JD stores in my area will not sell me a clutch puller.... Parts...
View Article6x4 Wiring
Hi Everybody! I have a 1995 Gator 6x4, gas, with the Kawasaki 2cyl water-cooled engine. I pulled the engine to replace a bad head gasket. Got everything back in, now the electrical system is dead. I...
View ArticleAre there any 825i parts break down manuals?
Are there any 2015/2016 825i parts break down manuals that show every nut and bolt listed with a part # ?
View ArticleTX Rack Remove and Replace
I am trying to remove and replace a steering rack on a TX. I have everything loose and the rack is not attached but I cannot figure out how to get the steering shaft through the fire wall through the...
View ArticleNewbie with pricing question
Greetings! New to the forum and wanted to post a question...what would you expect to pay for a 4x2 gator? I was on literally on my way to buy a 2000 for $3500 but the seller called and backed out....
View ArticleClik here to view.
Engine stalling in wet conditions
Hello, for quiet some time now, I am having this problem. Any time I get inside a shallow water (easy driving, not splashing) the engine stalls and can not be started for a while (20 min or so). I had...
View Articlefuel filter clips,....
Hello, I have a gator 825i and changed the fuel filter, but those pita clips that hold the fuel line on the filter are almost impossible to remove without breaking them, does anyone have a part number...
View ArticleLooking for a primary clutch that will fit a 1 1/8" shaft
I'm looking for a clutch for a Kohler Command 30 for my Ezgo Workhorse project. The crank is 1 1/8 with a 1/4 keyway. Did any of the Gators come with anything other than the 30mm 1:0 tapper? Thanks in...
View ArticleRSX 850i problems!
Okay I have a 2014 rsx850i with about 1400miles on it. It has recently been acting up, it starts hard (takes many cranks before it will start) but the bigger issue is the motor will only rev until...
View ArticleWindshield supplier..
Hello, im looking to put a windshield on my gator 825i, I have looked around at different suppliers, but am not confident in what they claim for the windshield holding up, does anyone have a supplier...
View ArticleHow many devices can be connected to the OPS Switch Bank
What do you do if you have more lights than there are switches in the OPS switch bank? I.E. 4 mid range lights on the front of the roof and 2 work lights on the rear of the roof.
View ArticleOEM Black Factory RSX 850/860 Door Inserts NIB for Sale
Hey Guys, I have a new set of OEM Deere Black Gator door closeout panels with the Gator logo on them in the box for sale. If interested call me 207-402-5020. They are in Southern Maine but can ship....
View Article2" lift
Just bought a 860I wanted to know if I add a 2" lift will it void the warranty? Lift will come from superatv.
View ArticleIdles Rough
Noob to the forum. Have an issue that I am trying to work through. Have had a 2012 625i for a couple of years now. Has run fantastic until recently (month or so ago). Starts fine and runs fine, just...
View Article