Well, it's been an unseasonably cold winter hear in central Indiana and I was having problems with my breath condensing on the inside of the windshield causing fog and ICE to build up when it was zero degrees (or a little colder!!) outside. Looked at the few options that were available. There are a few kits available and inspected quite a few heater systems that the Polaris crowd are installing. Everything from Mr. Heater propane heaters to high dollar automotive type heaters with defrosters and fancy switches. Also, just had a friend that got a tricked out Ranger 900 with all the bells and whistles, including the polaris premium cab, full heater, power windows and heated seats!! The amount of money spent to make a UTV as confortable as a vehicle is outrageous!! I could buy a base model Jeep for what some people are spending.
Anyway, I digress. My rationale for a heater was to keep the cab warm enough so that I could enjoy a little heat and make sure that my own breath didn't fog or ice the windshield (by the way, I run a Mammoth Soft cab on my RSX). Anyway, I also didn't want to drill holes in the top of my dash for the defroster option because I love the fact that I can hose out my cab when I wash it!!
Long story short, I installed an Aqua Hot unit in my machine this weak and am so far relatively happyy. Relatively easy install and puts out a decent amount of heat once the engine is warmed up. It's the same heater Kolpin advertises except you can get it on Amazon for considerably cheaper. Not singing praises by any means after only 24 hours, but I thought I would start a thread since there aren't any yet posted.
Anyway, I digress. My rationale for a heater was to keep the cab warm enough so that I could enjoy a little heat and make sure that my own breath didn't fog or ice the windshield (by the way, I run a Mammoth Soft cab on my RSX). Anyway, I also didn't want to drill holes in the top of my dash for the defroster option because I love the fact that I can hose out my cab when I wash it!!
Long story short, I installed an Aqua Hot unit in my machine this weak and am so far relatively happyy. Relatively easy install and puts out a decent amount of heat once the engine is warmed up. It's the same heater Kolpin advertises except you can get it on Amazon for considerably cheaper. Not singing praises by any means after only 24 hours, but I thought I would start a thread since there aren't any yet posted.