Hello I am new to this forum and looking for some assistance. I have a 2010 HPX with a Kawasaki vtwin engine. The machine starts fine and runs great until gas is applied then it spits and sputters and sometimes it will take off. Other times it seems to be running on only 1 cylinder. Here is a list of items I have done. Gator has 1743 hrs
Fuel pump flow test
Changed fuel filter
Changed oil made sure it was not overfull
Drained gas tank then added 93 octane
Checked valve clearance. In spec
Cleaned carb. Carb looked very good for most part but did have a lot of carbon. Main jets were 57 air adjustment screws set at 2 1/2 turns each. I am slightly above sea level.
Removed plugs. A lot of carbon put new plugs in BPR2ES
Spark arrestor removed.
Ran engine with out air intake -no change
Replaced one coil - my thought was it was loosing a cylinder. I could not find a test for this in the service manual. -no changed swapped the other two coils no change
Here are my questions
1. Has anyone had a igniter moduale failure on these? This is the first item before the coils on the wire diagram
2. My carbon problems, has anyone adjusted the carb to lean it out a little with the two adjustment screws on top? How about a hotter spark plug?
3. A thought I had was the exhaust is plugged robbing power but that may not explain the mis fire.
4. On my carb the parts manual shows two pilot jets on outside of either carb. Mine did not have those. Are there different carbs for different gas machines?
Thanks for any help.
Fuel pump flow test
Changed fuel filter
Changed oil made sure it was not overfull
Drained gas tank then added 93 octane
Checked valve clearance. In spec
Cleaned carb. Carb looked very good for most part but did have a lot of carbon. Main jets were 57 air adjustment screws set at 2 1/2 turns each. I am slightly above sea level.
Removed plugs. A lot of carbon put new plugs in BPR2ES
Spark arrestor removed.
Ran engine with out air intake -no change
Replaced one coil - my thought was it was loosing a cylinder. I could not find a test for this in the service manual. -no changed swapped the other two coils no change
Here are my questions
1. Has anyone had a igniter moduale failure on these? This is the first item before the coils on the wire diagram
2. My carbon problems, has anyone adjusted the carb to lean it out a little with the two adjustment screws on top? How about a hotter spark plug?
3. A thought I had was the exhaust is plugged robbing power but that may not explain the mis fire.
4. On my carb the parts manual shows two pilot jets on outside of either carb. Mine did not have those. Are there different carbs for different gas machines?
Thanks for any help.