Folks
2013 550 S4 w 200 hours
I am trying to change the cable on our gator, it was removed last year to be replaced but the wrong cable was supplied, so now I am trying to do it from memory (not good).
Referring to the JD parts catalog section 50, page 58. Cable #13 shows it attached to item #42, I am almost positive that the cable was attached to the cast bellcrank #56. Also it looks to me that the pin on #42 should go into the large (back) hole on #56, ours is just free floating, with only positive contact on the back side of #56. If it was in the back hole it would provide positive engagement both ways.
If someone could clarify this it would be greatly appreciated (I am in Panama, and there are no other machines to look at).
Thanks
2013 550 S4 w 200 hours
I am trying to change the cable on our gator, it was removed last year to be replaced but the wrong cable was supplied, so now I am trying to do it from memory (not good).
Referring to the JD parts catalog section 50, page 58. Cable #13 shows it attached to item #42, I am almost positive that the cable was attached to the cast bellcrank #56. Also it looks to me that the pin on #42 should go into the large (back) hole on #56, ours is just free floating, with only positive contact on the back side of #56. If it was in the back hole it would provide positive engagement both ways.
If someone could clarify this it would be greatly appreciated (I am in Panama, and there are no other machines to look at).
Thanks