New member here, but over the last 6 months I have been doing a lot of research and talking to people experienced with larger lifts on bikes. I understand everyone has their own experiences and opinions of shops but from everything I have found the most highly recommended shop in the industry(based on my recollection of conversations and from others experiences) is S3 in Shreveport LA. I myself have not had a SxS until the RSX I got last December. I haven't done any modifications to it until I felt I got a good amount of break in hours on it. Currently at 35 hours. My wife likes going to the parks around East Texas and riding, I myself would rather just ride around the deer lease. But after my experiences at the parks around here I figured out I am no where near tall enough to ride 60% of the trails with out sinking or severily damaging my machine. All that being said I would like to put a 4-6" lift to be able to clear 32-34" tires. And to give me the ground clearance to not high center in every other hole I come across. I'm not looking to play hippo I'd just rather not drown if it can be avoided. All that being said, I have been talking to S3 about making larger A arm lifts for the RSX but their reply was basically their isn't a demand currently for them. Which I understand but I was hoping there were some people on this forum that could give me some advice/experiences/different shop experiences/etc. so that maybe if I can get a large enough demand we can get some more lifts available for the RSXs out there. Sorry for the 2 chapters of a book. Look forward to replays and comments.
↧