I have a Gator 6x4 gas. It shut off as it was being driven one day. I decided to mess with it, and while attempting to find fuses, I located numerous wires which had been poorly repaired/replaced by the previous owner. (Forgot to mention the gator had no power at this point ie lights, lift, etc) I repaired the harness (engine harness remained hooked up and untouched), and put it back in the gator. The starter and ignition switch was also replaced at this point. The gator now has lights and will turn over. Two problems: (1) No power to coils, (2) If the starter does activate with the switch, the switch is in the 'run' position (1st click over). The ignition switch will not activate the starter by itself all the time. If I jump 12v to the starter, the starter will remain activated until I turn the ignition switch into the 'off' position. I checked voltage when the ignition switch is turned into the 'run' position, and the starter receives about 7 volts. Also if I turn the ignition switch to the 'start' position, I can hear another click. Any ideas what is going on with this thing?
↧