On a recent purchased 850d, the 4x4 was working normally. Then it wouldn't engage. Checked the electrics and found no power to the rocker switch. Jumped from a hot wire and 4x4 works. (all fuses are good)
In an on-line manual (not sure if it matches mine), it says front axle wont engage until rear wheels spin, is there a sensor or just a sprag type of bearing?
Anyone have a wire diagram of this circuit?
In an on-line manual (not sure if it matches mine), it says front axle wont engage until rear wheels spin, is there a sensor or just a sprag type of bearing?
Anyone have a wire diagram of this circuit?